Resmed HumidAire 3i Bedienungsanleitung PDF herunterladen (Seite 17)

OVER AND COVER SEAL

Inspect the cover and cover seal weekly for wear and deterioration. Replace any

damaged parts. When required, wash the cover and cover seal in warm water, using a

mild detergent (see previous caution). Rinse them thoroughly with clean water and

allow them to dry away from direct sunlight.

DOCKING STATION

Periodically wipe the outside of the docking station (including the connector seal) with

a damp cloth.

REASSEMBLING YOUR HUMIDAIRE 3i

Please refer to the illustrations in section I of the illustration sheet.

Reassemble the parts when they are clean and dry.

1 Align the cover seal to the guides on the cover (I-1) and press along the edges to

ensure it is fitted properly (I-2).

Put one cover arm into its pivot point on the docking station (I-3) and gently flex the

other arm into its corresponding point (I-4 & I-5).

The cover should be able to open and close freely while securely attached to the

docking station.

Replace the water chamber in the humidifier docking station (I-6).

SERVICING

With normal use of a HUMIDAIRE 3i, the water chamber needs to be replaced every

two years.

This product (H

UMIDAIRE 3i) should be inspected by an authorized ResMed Service

Center 5 years from the date of manufacture. Prior to this, the device is intended to

provide safe and reliable operation provided that it is operated and maintained in

accordance with the instructions provided by ResMed. Applicable ResMed warranty

details are provided with the device at the time of original supply. Of course, as with

all electrical devices, if any irregularity becomes apparent, you should exercise caution

and have the device inspected by an authorized ResMed Service Center.

338282r3.book Page 12 Friday, November 10, 2006 2:10 PM

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 90 91

Keine Kommentare

Resmed HumidAire 3i Bedienungsanleitung Seite 17